24/7 Emergency Service Available 0488 822 794

    Gas Fitter Sydney — Type A Licensed Installs, Repairs & Compliance

    NSW-licensed gas fitters for cooktops, hot water, heaters and leak repairs. Electronic detection, pressure tested, AS/NZS 5601 compliance certificate issued on the day.

    Available 24/7 across Sydney, Central Coast & Newcastle — 0488 822 794
    Tradetek team working on roof with safety harnesses
    Tradetek technicians setting up ladder
    Tradetek plumber inspecting pipes
    Tradetek roofer on rooftop with harbour view
    Tradetek plumber fixing kitchen sink
    Tradetek technician cleaning gutters with vacuum
    Tradetek worker inspecting gutter line

    How Our Gas Fitter Service Works in Sydney

    1

    Assess Requirements

    We evaluate your gas fitting needs — whether it's a new gas line, appliance connection, leak repair, or compliance check — and discuss the safest approach.

    2

    Plan & Quote

    We design the most efficient and safe gas solution, provide a detailed quote, and explain all compliance requirements.

    3

    Licensed Installation

    Our licensed gas fitters complete all work to Australian Standards, including pressure testing and electronic leak detection.

    4

    Certify & Document

    We issue all required compliance certificates and gas safety documentation, and walk you through safe operation of your gas appliances.

    About Our Gas Fitter Service in Sydney

    Gas work in NSW is strictly regulated under the Gas and Electricity (Consumer Safety) Act 2017 and AS/NZS 5601. Only a licensed gas fitter can legally install, alter or repair a gas appliance, and every notifiable job requires a Certificate of Compliance lodged with NSW Fair Trading. DIY or unlicensed work voids household insurance and can trigger immediate disconnection by Jemena.

    Tradetek Solutions runs a dedicated gas crew across Sydney, the Central Coast and Newcastle. We install and certify cooktops, ovens, gas hot water (Rinnai, Rheem, Bosch), continuous-flow units, instantaneous and storage heaters, BBQ bayonet points, pool heaters and patio strip heaters. Typical callout is from $189 and most cooktop or HWS swaps finish in a single visit.

    Leak detection is where most callouts start. We use calibrated electronic sniffers (methane and propane) plus a manometer drop-test on the meter to isolate the leak to a section of pipe – usually a corroded flexible connector, an old compression fitting under a cooktop, or a perished riser at the meter box. Repairs are pressure-tested to 7 kPa for a minimum 5 minutes before we re-commission.

    Sydney's older suburbs (Inner West, Eastern Suburbs, Lower North Shore) still carry a mix of black steel and early copper gas runs from the 1960s–80s, often re-routed during kitchen renovations without permits. We re-pipe in TracPipe CSST or copper to current standard, re-sleeve through walls, fit isolation valves at each appliance and issue the compliance paperwork your insurer and conveyancer will ask for.

    Every job leaves with a NSW Certificate of Compliance Gas (CCG), photos of the test gauge, and a written scope. If you're selling, renting or making an insurance claim, that documentation is what proves the system is safe – not a verbal assurance from a handyman.

    Whether you searched for licensed gas fitter sydney, gas leak repair sydney or gas cooktop installation sydney, Tradetek Solutions handles the job end to end across Sydney, the Central Coast and Newcastle. Call 0488 822 794 to book a licensed team today.

    What Our Gas Fitter Service Covers

    New gas line installation (copper and PE piping)
    Gas cooktop, oven, and stove connection
    Gas heater installation and connection
    Gas hot water system connection
    Gas BBQ bayonet point installation
    Gas leak detection with electronic equipment
    Gas compliance certificates for property sales
    Gas meter relocation and upgrades
    LPG to natural gas conversions

    Why Choose Tradetek for Gas Fitter in Sydney

    NSW-licensed gas fitters

    Authorised gas fitting licence holders – not general plumbers. Every job lodged with NSW Fair Trading.

    Certificate of Compliance same day

    AS/NZS 5601 CCG paperwork, pressure-test photos and scope of works emailed before we leave site.

    Electronic leak detection

    Calibrated methane/LPG sniffers plus manometer drop-test pinpoint leaks without unnecessary wall opening.

    Transparent pricing from $189

    Callout from $189, cooktop swaps typically $390–$650, full HWS install from $1,890 – quoted before we start.

    Gas Fitter Sydney — Frequently Asked Questions

    Need Gas Fittings in Sydney?

    Contact us today for a free, no-obligation quote. Fast response times guaranteed.